Vent Axia Tempra
Features & Benefits
- Fits in 100mm diameter hole – ideal for refurbishments
- Up to 84% heat recovery
- Available in 2 wall depths: 320mm and 460mm
- Reduces the home’s carbon footprint
- Choice of control options
- Summer setting
- Helps prevent noise ingress
- Continuous running or intermittent extract
- Meets current Building Regulations
- Approved Documents F and L
- Low SFP of 0.3W/l/s
- IPX4 rated
Through-The-Wall Mounted Heat Recovery Unit
The Vent-Axia Lo-Carbon Tempra is designed to fit in 100mm diameter hole and is suitable for refurbishment, kitchen, bathroom, toilet or utility applications. The unit meets the performance requirements for continuous extract fans under the current Building Regulations Approved Document F.
The Tempra is available in three models, a P version with pullcord control, a T version with overrun timer and an HTP version with built-in pullcord, overrun timer and humidistat. Two spigot lengths are available; 320mm and 460mm.
The manual summer setting allows the unit to be set to extract only, helping to prevent a dwelling becoming too warm in hot summer conditions.
Performance
Tempra can be set to run continuously at 6 l/s or 9 l/s, boosting up to 15 l/s, recovering heat from extracted air and returning it to the dwelling. The unique, compact heat exchanger has a temperature efficiency up to 84%, saving
energy and reducing your carbon footprint. For intermittent extract the Tempra is set to 15 l/s.
The Tempra is also designed so that the replacement air being introduced is at a reduced rate ensuring that the room being ventilated is still under a slight negative pressure. This ensures that fresh air is bought into the room from the rest of the house preventing humid air migrating to the rest of the house.
The Lo-Carbon ECDC motor with twin impellers consumes as little as 3.2 Watts on trickle rate and runs almost silently at only 20dB(A).
Typical Installation
The unique heat exchanger design allows the Tempra to be fitted in a 100mm diameter hole, allowing it to replace standard 100mm extract fans while giving all the benefits of heat recovery. Maximum wall thickness is 460mm.
A longer version of the Tempra is available, designed for installations where the wall thickness is between 321mm and 460mm. 460mm models are identified by an 'L'.